[Alex Pavlovic]

Hello !

I am desperately seeking access to service menu (factory mode) on Compaq P1220 Monitor (rebadged Mitsubishi 2060u).
I know that by holding down the Signal A/B (OSD OFF) button while turning the monitor on and then (-) button I get 255, then with (+) button to 5, but after that but I cannot get any further. I tried right arrow button , up arrow button etc but nothing gets me to the service menu.
Please help !!! I can eventually understand if you write in Russian, but I can only write back in English, German and Serbian.

Thank you very much !!!

[LaAndy]

1. Turn the power ON while holding down the Input Connector Select / OSD OFF button.
2. After step 1. , release the button after one to two seconds.
3. Confirm that 00 is displayed for the counter on the OSD display, and set to 225 with the "-" ADJUST button.
4. Set to 05 with the "+" ADJUST button.
5. When the Input Connector Select / OSD OFF button is pressed, the factory mode will be entered.
This factory adjustment mode is entered with the above steps.

The factory adjustment mode remains valid even after the power is turned OFF.
Note that steps 3. to 4. must be carried out within ten seconds. If ten seconds are exceeded, the mode will return to the user mode.

Best regards!
_________________
В бочару его, в бочару и по кумполу!

[Алекс]

1.Turn the power ON while holding down the input Connector
Select/OSD OFF button.
2.After step 1, release the button after one to two second.
3.Confirm that 00 is displayed for the counter on the OSD display,
and set to 225 with the (-) ADJUST button.
4.Set to 05 with the (+) ADJUST button.
5.When the input connector select/OSD OFF button is pressed,
the factory mode will be entered.

[Гость]

Thank You Very much !

[Alex Pavlovic]

If you guys would share a complete pdf service manual for Mitsubishi 2060u as well that would be fantastic.

Thanks a lot again.

Alex