[FuLLcOnTroL]

mnq rusky ploha q est daewoo cmc-719b mnq nuzna Прошивки cmc-719b 24c08 spasiba
problem after turn off coputer monitor dont get auto standby i fixed all electronic corrupt problem service menu adjusment setting work and set. system not detect from eprom minimum maxsimum H/V resulation to get standby

[прохожий]

Ты уж пиши или чисто по аглицки (хотя конференция русскоязычная!) или уж по русски английскими буквами...

[MVI]

FuLLcOnTroL
You can write and in English. Only ALL letters in each word, pls. Ok?

[Elnew]

You absolutely sure the problem is in EEPROM dump?
CPU can't detect critical levels of H/V-sync due to incorrect data in EEPROM? I have the same problem with NEC FE700+. In my case CPU hold #POFF and #SUSPEND high even after h/v-sync is full off. Moreover CPU generates free-running signal to deflection circuits. Maybe anyone has the dump you need and upload it. Please post what you get after EEPROM-reprogramming here.


Он просит прошивку к DAEWOO CMC-719B, полагая, что процессор не входит в standby, будучи не в состоянии определить порог синхросигналов (граничные частоты видимо) по входам. Хмм...

[FuLLcOnTroL]

thank you all for the interest my problem im looking here for cmc719b eeprom file thanks again